In the traditional seven-star float, first place the seven floats close to the lead seat, add lead, and float the last float into the water. The tail of the float is level with the water surface and the entire line group is suspended in the water. After catching the fish, pay attention to the position of the fishhook in the fish's mouth and then adjust it. Weigh the hook weight
We will take out the double hooks of the fishing group that has just been set up and throw them into the water. Because the net weight of the entire fishing group has been reduced to a certain extent, the number of mesh meshes exposed by the float will be certain. increase, here we assume that the weight of a single hook is three mesh. Then after we take out the double hooks, the mesh number of the entire fishing group exposed to the water should be ten meshes. We will regard these ten meshes as the final point of this fishing group. When we set the fishing mesh later, As long as the fishing eye is ten fishes beyond this final point, it means that the figure-eight ring has touched the bottom. Set the fishing mesh
The fishing mesh you just set is four meshes, so how many meshes should you fish now? Judging from the conclusion that we have just accurately measured the hook weight and bait weight, the weight of a single bait is 1.5 mesh lighter than the weight of a single hook. When this type of bait is lighter than the hook, we usually use lower mesh to catch high mesh. , and this fishing adjustment difference is slightly larger than the total weight difference between the bait and the hook. The weight difference between a single bait and a single hook is 1.5 mesh, so we can define the fishing adjustment difference as two meshes. If we adjust the fishing adjustment to 4 meshes to catch a 6 mesh, it will be fine. If we adjust the fishing group to 4 to fish 6, then the fishing group will be lower hooked. Lie on the bottom with the bait touching the bottom. Pulling bait to adjust fishing
If you haven’t compared it, many fishing enthusiasts may not believe it. In fact, pulling bait is much lighter than rubbing bait, so when entering the water, the lowering of the bait is slower and not too fast. Pressing and drifting, if you use pulling bait for fishing, but use the fishing method of rubbing bait to adjust the drift, it will not work. Therefore, the key to the difference between pulling bait and rubbing bait lies in the net weight.
We sometimes adjust the bait to 8 mesh or 10 mesh, but if the bait is adjusted so high, the fish float cannot press it down at all, causing both baits to float off the bottom. How to adjust the float by pulling bait? The first step is to lower it significantly. Even when fishing in black pits in ponds, it is enough to adjust it to 5 or 6 mesh. When fishing for big fish, it can be less. Rubbing bait and pulling bait
For example, rubbing bait is mainly used for bottom fishing and is basically suitable for all kinds of fish. It can reduce the harm caused by small fish and reduce the risk of hooking. Compared with rubbing bait, pulling bait takes up the bait faster, the environment is stronger, and the palatability is more. However, the bait ball used to pull the bait is small and light. This is an advantage but also a drawback. The bait is lighter, and the speed is slower after all. It is generally unable to resist small fish, and it is most likely to cause the bait to be unable to reach the bottom.