1, heavy lead to find the bottom and measure the water depth.
The fishing group hangs heavy lead, drags the float into the water, and then pushes the float upward until the water surface is exposed 1 mesh. The distance between the tip of the float and the plumb drop is the water depth.
You can't just measure a little water depth. Take the fishing point as the center, from front to back, from left to right. If the drifting eyes are all one eye, it means that the bottom of the water is flat. If the drift eye is high and low, it means that the bottom of the water is uneven, so it is necessary to change the landing point and find a relatively flat point as the fishing point.
Step 2 adjust your eyes
After measuring the water depth, push the float down to a distance of 10 cm, and then start trimming the conductor until the float is above the water. With a few eye adjustments, the water will float a few times.
3. Secondary adjustment of hook
Tie the auxiliary line to the eight-character ring, throw the fishing group into the water and observe the change of drifting purpose. The number of floating eyes is the number of pressing eyes of the double hook.
4. Fishing.
Hook the bait, throw the fishing group into the water, and observe the change of drifting purpose. The number of floating eyes is the number of pressing eyes of a single bait, then the bait is hung on the upper and lower hooks, and then the fishing group is thrown into the water.
Let's look at the reduced number of floating eyes. If the reduced number of floating eyes meets the number of double baits, it means that there is no problem in adjusting fishing. At this time, the number of floating eyes exposed to the water is fishing eyes.