▲ Before the toilet is installed, the sewage pipe should be thoroughly inspected to see if there are dirt, sand, waste paper and other sundries in the pipe.
▲ At the same time, you should also check whether the ground where the toilet is installed is level. If the ground is uneven, please level it.
Second step
▲ Turn the toilet over and determine the center on the toilet outlet.
▲ Draw the center line of the cross at the same time, and the center line should extend to the feet around the bottom of the toilet.
Third step
▲ Align the crosshair on the toilet with the ground sewage outlet and install the toilet horizontally.
▲ At the same time, press down the sealing ring hard and install the anchor screw and decorative cap.
Fourth step
▲ Install a special sealing ring at the toilet drain.
▲ Or put a circle of glass glue (putty) or cement mortar around, and the cement-sand ratio is 1: 3.
Step five
▲ Drain water for 3-5 minutes to flush the pipeline to ensure the cleanliness of the water pipe.
▲ Install the angle valve and connecting hose again.
▲ Then connect the hose with the water inlet valve of the installed water tank fittings, and press the water source.
Step 6
▲ Check whether the water inlet and seal of the water inlet valve are normal.
▲ Check whether the installation position of the drain valve is flexible, whether there is blockage and leakage, and whether there is leakage into the water valve filter device.