The adjustment of the supporting wheel of rotary kiln refers to the reasonable adjustment and control of the supporting wheel to ensure the long-term safe and stable operation of rotary kiln, so as to keep it in good operation state, improve the operation rate and reduce the operation cost.
Related information:
The rotary kiln is supported by two gears with high control sensitivity. During adjustment, it is required that the center lines of the four idlers of 1 gear and 2nd gear deflect counterclockwise and be parallel to each other at the same time, so as to ensure that the two idlers can simultaneously give upward force to the pulley and avoid the phenomenon of "big eight" and "small eight".
As far as the center lines of the four rollers in 1 and 2 gears are concerned, the center lines of the rollers in the two gears are inclined in opposite directions, and the center lines of the rollers form two splays transverse to the kiln body. The forces acting on the tire cylinder by the two gears are either opposite or opposite, which cancel each other out, which will accelerate the wear on both sides of the tire and the iron block, and make the cylinder between the two gears stretch or lengthen.