2. Tie a fishhook on each sub-thread by internal knotting, and then prepare the main thread of 100 cm, and tie the main thread and fishhook together to prepare the knot. The node is 20 cm away from the short side of the main line and 5 cm away from the hook side of the secondary line.
3. Thread the longer end of the main wire on the coil for three or four times, and then tighten it. Cut off the extra ends of the sub-wires. The main line and the secondary line are wound on the coil, and the long end of the main line and the non-fishhook end of the secondary line are tightened after passing through the coil for three to four times. In order to prevent the hooks from hanging together, it is best to ensure that the distance between two adjacent nodes is greater than the total length of two adjacent sub-lines.
4. Then tie all three sub-lines to the fishing line, then pass the splay ring through the end of the folding line, adjust the distance between the splay ring and the adjacent nodes to about 10 cm, and cut off the redundant lines after the thread ends are tightened.
5. After one end of the main line is folded in half, it passes through the splay ring, then the splay ring passes through the folded end, and the splay ring is fixed after tightening.