1.
Material preparation: an 80cm red rope and a 2m red rope.
Operation steps:
1. Fold the 80cm rope in half, leaving 12cm at the fold, and clamp it with a clip. Clamp the other end directly. Then fold the two-meter rope in half to find the center point, and place the center point under the axis. Then pull the thread on the left to the right. Then pass the thread on the right through the hole on the left from under the thread on the left, thread it up, then tighten the thread and push it to the clip.
2. Use the thread on the right to pull it to the left. Reinsert the left thread. Hold the thread on the right and pass it under the axis and through the circle on the right. Then pull the thread tightly and push it to the clip. Then continue to repeat, step 1, 2, and continue to braid like this.
3. This is the effect picture of a section.
4. After braiding to the required length. Cut off the ends of the braided wire and burn it with a lighter.
5. Overlap the thread ends on both sides of the axis, tie a double flat knot to the required length, cut off the thread ends and burn them with a lighter.
6. There are two thread ends on each side of the axis, and they are tied together with a knot.
7. Below is the braided bracelet.
2.
There are many ways to weave red rope, such as unity knot, 8-byte knot, auspicious knot, Peru knot and so on. Here is a brief introduction to two methods of braiding red rope.
1.8-shaped knot
A single line is formed by crossing another single line in a figure-eight shape, so it is called a figure-eight knot. The pronunciation of the word "eight" is similar to that of the word "fa", and it has a good meaning of development, so it is often used at the end of the Chinese knot.
2. Cross knot
The cross knot has a cross on one side and a mouth on the other side. Often used in three-dimensional structures, such as firecrackers, crosses, etc.
3. Double connection
A double connection consists of two single dead knots interlocking to form an X shape, which means adding pairs. The structure is simple and firm and should not be loose. It is often used to connect other structures.