Tools/Materials Fine wire, wire cutters, nail polish
0 1 Prepare wire cutters, gel pens, fine wire and nail polish. As shown in the figure below, wrap the thin thread around the gel pen.
Take off the gel pen and circle it with the remaining iron wire, as shown in the following figure 1. Take off the thin wire again and make two turns as shown in Figure 2 below, and then repeat the previous operation for six turns, as shown in Figure 4 below. Then we adjust the position of the six iron rings so that three are above and three are below.
03 After adjustment, see the figure below.
Clamp the iron ring with wire cutters to make it oval as shown in the following figure 1, and then clamp the oval as shown in Figure 2 to make it petal-shaped as shown in Figure 3.
Apply nail polish horizontally on the petals as shown in the following figure, as shown in Figure 3 below, and then set aside until the nail polish is dry.
The finished product after drying is as follows. Choose a red bead and stick it in the center of the petal, as shown in Figure 3 below.
Wrap the remaining iron wire around the mineral water bottle, and choose the winding position of the mineral water bottle according to the size of your hand, as shown in the figure below. Take it off after winding, as shown in Figure 3 below.
At this point, our bracelet is ready. Have you learned?